![]() Take two nuts and screw them onto the standoffs from the other side of the plate. We found that the pre-drilled holes in the top plate only allowed us to place two standoffs in the Arduino because of the positioning of the holes in the plate and the holes in the Arduino.įind two of the shorter standoffs provided in the kit and place them in the holes you are using. Find two holes in the plate that align with your Arduino board. You should have two ends of red wire coming off of the red wire that is attached to the switch. Take the red wire coming from the power switch and place it in the other end of the terminal. Take a crimper and press on the connection as hard as you can. Take a wire crimping terminal and push in the end of the twisted red wire as far as it will go. Take the two newly cut red wires and tightly twist the ends together. Separate and strip the ends of all the wires. Cut two pieces of 8 inch red wire and two pieces of 8 inch black wire. The other wire attached to the switch then becomes your red “power” line, and you will use this line and the black wire from the battery pack to supply power to your motors.īecause there are two motor controls, there needs to be two black lines and two red lines to supply power to each of the motor controls. Solder the red wire coming from the battery to one of the wires you soldered to the switch. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |